©2021 Spyker Spreaders/A Brinly-Hardy Co.
Page 10
1019225-D
Assembly
1. After removing all the parts from your box, place the
pre-assembled hopper portion in your work area.
Start upside down and facing this direction:
4. Run two Hex Head bolts (44) through the frame
(See Fig. 4 for alignment). Lower the tubing for the
stand (59) on the bolts and secure in place with two
Nylon Lock Nuts (3).
Tighten completely with a 7/16” socket & wrench.
Start with
this side.
Fig. 1
2. Add 2 washers (62) to the wheel axle (31). Slide on
the tire (63).
If last washer does not fit, remove tire &
one of the interior washers.
Lock the wheel in place with the Clevis Pin (65) and
Cotter Ring (66).
65
66
63
62
31
Fig. 2
3. Add 1 washer (62) to the wheel axle (31), then slide
on the tire (63) and an additional washer (62).
NOTE: If necessary, add the provided additional
washer to reduce play in the axle.
Secure in place with the Rue Ring Locking Pin (61).
(See figures 3b and 3c below).
61
Fig. 3c
Fig. 3b
61
61
62
31
62
63
Fig. 3
3
3
44
44
Fig. 4
Front
59
