©2021 Spyker Spreaders/A Brinly-Hardy Co.
Page 11
1019225-D
Assembly
7. Add the Handle Weldment (41) by lining it up on the
Lower Handle tubing from step 6.
Secure the Handle in place by running four Hex
Head Bolts (46) through the two handle ends from
the outside. Tighten with four Nylon Lock Nuts (3)
from the inside of the Lower handle (52).
Tighten with a 7/16” socket & wrench.
Fig. 7
41
52
46
46
3
5a. The existing
hardware
(illustrated here)
may need to be loosened
for the next two steps.
5c. Align the two holes of the Lower Handle (52) with the
two holes of the outer, rear edges of the Frame (59).
Place one of the Lock Washers with teeth (76) between
the square hole of the Handle (52) and the curved slot
on the Frame (59).
Starting from the inside of the Frame, run a Carriage
Bolt (56) through the curved slot of the Frame (59). The
Carriage Bolt will also pass through the square hole of
the Lower Handle (52).
The end will be facing out.
Loosely
secure with a washer (54) and a Nylon Lock
Nut (53).
Use a 1/2” Socket & Wrench.
Repeat on the
other side.
Do
NOT
tighten (yet).
Fig. 5
53
53
59
54
54
52
76
76
56
56
6. Add one washer (54) to a hex head bolt (55).
Starting from the outside edge, run the bolt through
the circular holes of the Lower Handle (52), Frame
(59) & Bracket (82 or 83), then
loosely
secure with
another washer (54) & a Nylon Lock Nut (53).
Use a 1/2” Socket & Wrench.
Repeat on the other side.
Do
NOT
tighten (yet).
55
59
59
54
54
54
54
52
53
53
55
FLIP
SPREADER
OVER
5b. Remove hex
head bolt (55),
washers (54), &
lock nut (53).
NOTE: Set aside,
these will be
reinstalled in step 6.
L
OOS
E
R
E
M
OV
E
