Spyder XTRA, Руководство пользователя

Страница: 14 / 36

11
Eko™ CUP SEAL REMOVAL
SCR019
SCR031
ASA026
LPC036
SPR016
ITP023
ORGOO8
FRG028
VRT036
FRG038
ITP026
STEP BY STEP Eko™ CUP SEAL ACCESS
Access of the Eko™ Cup Seal for service or replacement requires the removal of the Front Plug and Vertical CA
Adapter.
STEP 1
Unscrew the CA Adapter screws and twist off the Foregrip and Foregrip Adapter from the Vertical Adapter.
STEP 2
Remove the Vertical Adapter by unscrewing the Vertical Adapter Mounting Screw, be sure to keep a finger
over the Front Plug to prevent it from springing out. NOTE: The Front Plug and Vertical CA Adapter are both held in
place by the Vertical CA Adapter Mounting Screw.
STEP 3
Pull the Front Plug out and it should come out with the Valve Spring, Eko™ Cup Seal Guide, Eko™ Cup Seal
and Eko™ Valve Pin all together.
STEP 4 Unscrew the Eko™ Cup Seal from the Eko™ Valve Pin and replace with the spare provided with your spare
parts kit.
STEP 5 Follow the previous steps in reverse to re-install all components properly. Make sure the Front Plug screw
hole is lined up with the vertical adapter screw hole.
IMPORTANT: Always make sure all air sources have been removed from your marker and any residual air has been
vented out completely before servicing your marker.
NOTE: Service or replacement of the Eko™ Cup Seal should only be done if a leak is present and can be heard from
the breach after the removal of the Delrin Bolt.
Part Names and Numbers describe in this section:
C/A Adapter (#ASA026)
Vertical Screw (#SCR031)
Vertical O-ring (#ORG008)
Vertical Adapter (#VRT036)
Cup Seal (#ITP023) Eko™ Valve Pin (#ITP026)
Valve Spring (#SPR016)
C/A Adapter Screw (#SCR019)
Front Plug (#LPC036) Gas Thru Foregrip (#FRG028)
Gas Thru Foregrip Adapter (#FRG038)