Spyder MR6, Руководство пользователя

Страница: 9 / 32

English
6
INSTALLING / REMOVING A SHOULDER STOCK
Place the Shoulder Stock in the top breach of the Receiver
behind the Venturi Bolt. Once the Shoulder Stock is in place
secure the Stock with the set screw provided, then tighten
with the Allen wrench.
To adjust the length of the Shoulder Stock press and hold
the Lever for adjustment. Once the Lever is released this will
lock into position.
Loosen the set screw on the right side of the Receiver with
the Allen wrench. Then remove the Shoulder Stock out the
top breach of the Receiver. HELPFUL TIP: The Shoulder
Stock must be removed if intended to clean the marker.
(SEE DISASSEMBLE/REASSEMBLE AND CLEANING OR
REAR INTERNALS).
VELOCITY ADJUSTMENT INCREASE / DECREASE
To INCREASE your velocity FPS (Feet Per Second) using
the Allen wrench turn the Velocity Adjuster / Spring Guide
clockwise.
To DECREASE your velocity FPS (Feet Per Second) using
the Allen wrench turn the Velocity Adjuster / Spring Guide
counter-clockwise.
NOTE: The velocity of this paintball Marker ranges from
approximately 220 - 300 feet per second (fps). Velocities
will fluctuate or vary due to paintball size, climate condition,
altitude, type of air source and variance in spring tension
from manufacturing.
WARNING
• The recommended Velocity speed should be no greater
than 300 fps. Not doing so can cause serious injury if the Velocity is dangerously high.
• Paintball markers are not intended to shoot any person less than 30 feet.
• Never point a loaded marker at any person who is not wearing the proper face protection.
• Never at any point should you look down the barrel, whether the marker is loaded or not.
• Using a paintball marker outside a non designated paintball field can be illegal, and is subject to law
enforcement penalties if property damage is caused by the user.
A JAMMED PAINTBALL
In the event of a paintball break and the Venturi Bolt jams, follow these steps to help un-jam the Marker. The
Markers breach is located where the barrel starts to thread in the Receiver and underneath the Markers feed
neck. Before attempting to un-jam the Venturi Bolt you should always have your Goggles or Safety Glasses on.
Make sure the Marker is in the SAFE MODE position before attempting to un-jam the Venturi Bolt. Remove the
CO2/Compressed Air Tank before attempting to un-jam the Marker. Remove all paintballs from the Magazine
and Loader. Have the barrel removed from the Receiver to allow the paintball(s) to exit. With enough force on
the Cocking Knob, pull back to release the Venturi Bolt from the jammed position. Another method is to use
a “Straight Shot Squeegee” or the end of a wood dowel rod; push against the face of the Venturi Bolt with
enough force to release the jammed Bolt. Always clean the paint from the breach and barrel to enhance the
performance of your Marker.
DANGER: Never look down the barrel of the Marker when loaded or unloaded. Remove the attached CO2/
Compressed Air Tank before attempting to un-jam the Venturi Bolt. NOTE: Never use a metal rod or screwdriver
as a tool to push on the Venturi Bolt, anything metal will scratch and damage the inside of the Marker.