SPXFLOW Universal 5000 Industrial Series, Инструкция по эксплуатации, Страница: 27 / 58

25
95-03012
REAR
BEARING
V-BLOCK
FRONT
BEARING
REAR
GREASE
SEAL
BEARING RE-
TAINER
BEARING
SPACER
V-BLOCK
11. Scrape silicone sealant; press out and discard
grease seal from front bearing retainers.
12. Remove shims. If they are to be re-used,
identify them with the shaft on which they were
used.
13. Press out and discard both rear grease seals in
gear case.
3. Secure shaft assembly in a soft jawed vise as
shown. Open tab in lock washer. Remove front
bearing lock nut using a spanner wrench or drift
punch.
4. Remove front bearings using V-blocks and a
hydraulic press. (See Table 4 on Page 35.)
5. Clean and inspect all parts thoroughly if they are
to be re-used.
ALL MODELS EXCEPT 5080
1. Use hydraulic press and V-blocks to remove
bearings and spacer. (See Table 4 on Page 35.)
MODEL 5080
2. Remove rear bearing by using V-blocks and a
hydraulic press. (See Table 4 on Page 35.)
SHIM
SILICONE
SEALANT
GREASE
SEAL
LOCK NUT
V-BLOCKS
BEARING