8
TJM60AG
T
ank
Cleaner
ǀ
08/07/2017
INSTALLATION
Installation for connecting barrel washer to pressure washer pump and air compressor.
Tools needed for assembly
1 . Adjustable Crescent Wrench
2. Pipe Wrench
Step 1 .
First connect air hose from air compressor to trigger
valve located on handle coupling marked air. Air hose
must be a minimun 1/4 inch size. An air filter with a 40
micron filter and air pressure regulator need to be installed
to allow for proper operating performance. The air filter
should be installed after the air compressor, next the air
pressure regulator and then the air hose to the trigger
valve. If your current systems does not have an air filter
pressure regulator, then this optional item can be provided
by Spraying Systems Co.. Important safety note: Never
connect a water hose line to the trigger valve located on
the air line!
Step 2 .
Before connectig hose, make sure to flush water line from
pressure washer pump. Next, connect the high pressure
hose 3/8 NPT size from the pressure washer pump to the
3/8 NPT ball valve located near the handle coupling marked
water. Important: high pressure water hose must have a
minimum pressure rating of 1,500 psi. It is suggested to
use a lquid strainer with a 100 mesh screen side on the
inlet suction side of the pressure washer pump . If a strainer
is needed Spraying Systems Co. can provide a strainer as
an optional item .
Connect air
hose from
compressor to
trigger valve
Trigger
valve
Connect high
pressure washer
hose from
pressure washer
pump to 3/8 NPT
ball valve
3/8 NPT
ball valve
