22
5. OVERVIEW OF THE SUP BOARD
Top View
1 - Action Cam Mount 2 - Tension Cable 3 - Carry Handle 4 - Floor Space 5 - Valve
6 - Ring for safety leash 7 - Kayak Seat Rings (4 x)
Bottom
8 - Middle Fin 9 - Side Fins
6. SUP BOARD PREPARATION
Unpack and Roll out the SUP Board
1. Check the planned installation site: The surface where you place the board must be sufficiently level,
clean and free of pointed or sharp objects.
2. Lay down the rolled-up SUP board and, if necessary, remove it from the transport packaging.
3. Roll out the SUP board evenly.
Inflate the SUP Board
1. Unscrew the protective cap from the valve of the SUP board and put it in a safe and clean place.
2. Check that the valve is clean.
3. Check that the valve is in the inlet position. For this:
• Depress the pin in the center of the valve.
If the pin stays down, the valve is in the exhaust position. Then press
the pin again so that it jumps to the up position. The valve is now in the
inlet position.
Use the supplied hand pump or another suitable low-pressure pump to
inflate.
• Do not use a compressor! The high pressure can irreparably damage the material of
the SUP board.
Pin in up position: valve is in
inlet position
1
2
3
4
5
9
8
6
7
