42
MICRO INVERTER
Circuit Board & Product Settings
frequency setting:
MI-250 can detect the frequency automatically without setting.
Connecting to grid power:
After MI-250 is installed into Green System products, the power can be
linked to grid power through product power cord, as shown in the following
figure. Attention: it is necessary to cover the power cord and Green system
connecting area with a metal cover. Turn the product power switch to OFF
and unplug the power cord from the wall outlet before pulling the plug from
the product. If the plug is pulling while it is connecting to the power grid, it
might cause the electric arc and damage the plug
Grid power voltage
The ratting of a
branch circuit
Number of products
230V
10A
9
220V
10A
8
120V
15A
7
110V
15A
6
The number of products can be linked to a branch circuit of the grid
power:
the max wattage output of MI-250 is 250W. Pay attention to the
electricity capacity limit (the ratting of overcurrent protective device) to avoid
overload. Different grid powers voltage limits are shown as the following
table.
Power on:
Start running the elliptical trainer with 40SPM or above for more than 6
seconds to turn on the unit. Start operating the elliptical trainer when the
display enter Banner page.
If the elliptical trainer cannot be turned on or the display turns dark or shows
”PLUG IN SOCKET”. Insert the power cord into the power supply socket and
start running the elliptical trainer.
When the elliptical trainer is stop running and no other activity for 2 minutes,
the elliptical trainer will shut down. Start running the elliptical trainer to restart
the unit.
