6. PROGRAMMING YOUR FINGERPRINT
9
St
ep 1
1. Behind the front panel, inside the
right hand side of the vault, you
will find a reset button.
2.
Press the reset button to start the
programming process. You will
hear one beep and the indicator
ring will illuminate on the front of
the door
.
NOTE: Recording mode will time out
after 10 seconds of inactivity. If this
occurs press reset button and begin
again.
3.
Place and hold the pad of your
finger on the scanner
until it flashes
green and beeps one time.
4.
Repeat at least 3 more times until
there are
2 consecutive beeps and
2 green flashes.
IMPORTANT: Be sure to
use the same finger for each
recording sequence.
BEEP
BEEP
BEEP
HOLD FOR BEEP
LIFT FINGER
St
ep 2
St
ep 3
St
ep 4
BEEP
2 BEEPS + 2 GREEN FLASHES = SUCCESS!
RESET BUTTON IS
LOCATED BEHIND
THE FRONT PANEL
PRESS THE
RESET BUTTON
