14
1-800-732-0144
WWW.SPORTDOG.COM
15
TO RETURN THE UNIT TO THE FACTORY ID FOLLOW THESE STEPS:
1.
Turn the Intensity Dial to V/T, and then press and release the Mode Button on the back of your Remote
Transmitter. This doesn’t change the mode, so the current mode will still be active after the ID change is
complete.
2.
Don’t press any buttons and wait until the green Transmitter Indicator Light turns off.
3.
You’ll need to match the Collar Receiver to the Remote Transmitter (see STEP 5 on page 12).
TAKING YOUR DOG OUT OF THE BOUNDARY AREA
IMPORTANT: Remove the Collar Receiver from your dog.
Option 1
: Replace the Collar Receiver with a regular collar. Put your dog in a
car that’s within the Boundary Area and drive him out of the Boundary Area.
Option 2
: Replace the Collar Receiver with a regular collar and lead/leash.
Walk your dog out of the Boundary Area while giving a command such as “OK”
at a specific place of the Boundary Area (the end of your driveway, sidewalk,
etc.). Always leave the Boundary Area with a lead/leash at this place and your
dog will associate leaving the Boundary Area only on a lead/leash, only at
this place, and only with a person. You may initially need to convince your dog
to leave the Boundary Area with a food treat and lots of praise. You may also
carry your dog out of the Boundary Area.
Option 3
: Put the Collar Receiver in
Training
mode.
TERMS OF USE AND LIMITATION OF LIABILITY
1.
TERMS OF USE
This Product is offered to you conditioned upon your acceptance without modification of the terms, conditions,
and notices contained herein. Usage of this Product implies acceptance of all such terms, conditions, and
notices.
2.
PROPER USE
This Product is designed for use with dogs where training is desired. The specific temperament of your dog
may not work with this Product. We recommend that you not use this Product if your dog is less than 10
pounds or if your dog is aggressive. If you’re unsure whether this is appropriate for your dog, please consult
your veterinarian, certified trainer, or contact our Customer Care Center.
Proper use includes reviewing the entire Operating Guide provided with your Product and any specific safety
information.
3.
NO UNLAWFUL OR PROHIBITED USE
This Product is designed for use with dogs only. This dog training device isn’t intended to harm, injure, or
provoke. Using this Product in a way that is not intended could result in violation of Federal, State, or local
laws.
4. LIMITATION OF LIABILITY
In no event shall Radio Systems Corporation be liable for any direct, indirect, punitive, incidental, special or
consequential damages, or any damages whatsoever arising out of or connected with the use or misuse of this
Product. Buyer assumes all risks and liability from the use of this Product.
5.
MODIFICATION OF TERMS AND CONDITIONS
Radio Systems Corporation reserves the right to change the terms, conditions, and notices under which this
Product is offered.
BATTERY DISPOSAL
This system operates on 2 lithium-ion battery packs (950mAh capacity for the Collar Receiver and 200mAh
capacity for the Remote Transmitter). Only replace with battery received from calling the Customer Care Center.
Separate collection of spent batteries is required in many regions; check the regulations in your area before
discarding spent batteries. Please see below for instructions on how to remove the battery from the product for
separate disposal. If you wish to ship us your spent batteries for disposal, contact the Customer Care Center.
At end of product life, use these battery-removal instructions for final disposal (don’t open the Collar Receiver or
Remote Transmitter until you’ve received the replacement):
•
Using a #1 Phillips screwdriver for your Remote Transmitter and/or a 3/32 Allen wrench for your Collar
Receiver, remove the case screws.
•
Remove the case back or cover.
•
Remove the old battery pack
•
When removing the old battery pack, care must be taken when gripping the connector firmly to avoid
damaging the wires. Shorting the battery wires may cause fire or explosion.
•
These instructions aren’t valid for repair or battery replacement. Replacing the battery with a battery not
specifically approved by Radio Systems Corporation may cause fire or explosion. Please call the Customer
Care Center to avoid invalidating your warranty.
