6
1-800-732-0144
WWW.SPORTDOG.COM
7
TO TURN THE COLLAR RECEIVER ON/OFF
Press and release the power button (located between the Contact Points) for about one second - the unit will
power on immediately, as well as beep 1-3 times, depending on the static stimulation range setting (2 is the default
setting). To turn the unit off, press and hold the power button for 3 seconds. A long beep will sound, then the unit
will turn off.
NOTE: If the user does not press any button, the display will go blank after 15 seconds. To wake up the display,
press and release the power button.
CHANGING THE MODES
The C Train
™
system has 3 modes of operation. These 3 modes are indicated by icons shown on the OLED
display. The following table summarizes the modes and their corresponding icons:
When the display is active (on), press and release the power
button. The mode icon will flash, indicating that you can
change modes. Press the plus and minus buttons until the
desired mode is selected.
TO SET THE CORRECTION LEVEL
CHANGING THE STIMULATION (CONTAINMENT)
After changing modes, pressing and releasing the power
button again while the mode is flashing will allow you to
change the static stimulation levels for Containment, if you
are in
Containment
or
C Train
modes. Pressing the
plus or minus buttons will cycle through the static stimulation levels (1-7). The music note indicates tone/vibe
(no static stimulation). Begin training with static stimulation Level 1 and only increase if your dog does not respond
to the static stimulation.
CHANGING THE STIMULATION (TRAINING)
Static stimulation level, tone, and vibration are controlled by the Remote Transmitter when the unit is in
Training
and
C Train
modes (See STEPS 3-4).
CONTAINMENT ONLY
TRAINING ONLY
C TRAIN
MODE
DISPLAY
PLUS/MINUS
BUTTONS
COLLAR RECEIVER INDICATOR LIGHT
OPERATIONAL
MODE
LIGHT
COLOR
BATTERY
STATUS
LIGHT
FUNCTION
SPEAKER
FUNCTION
VIBRATION DISPLAY
Unit is turned on via
power button
Unit is turned on via
power button
Unit is turned on via
power button
Green
Orange
Red
Good
Medium
Low
Light is solid in
color during beep
sequence
Light is solid in
color during beep
sequence
Light is solid in
color during beep
sequence
Beeps 1-3 times
depending
on static
stimulation
range setting
(2 is the default
setting)
N/A
Unit will
display the
current battery
level, mode
setting, and
containment
stim level if
Containment
mode is
enabled
Unit is turned off via
power button
Red
N/A
Light is solid in
color during beep
sequence
Beeps
continuously
for 2 seconds
N/A
N/A
Unit is on
Green
Good
Light flashes every
4-5 seconds
N/A
N/A
N/A
Unit is on
Orange
Medium
Light flashes every
4-5 seconds
N/A
N/A
N/A
Unit is on
Red
Low
Light flashes every
4-5 seconds
N/A
N/A
N/A
Unit is on and the
power button is
pressed and released
Red
N/A
Light will quickly
flash
N/A
N/A
Unit will
display the
current battery
level, mode
setting, and
containment
stim level if
Containment
mode is
enabled. Use
the power
button to select
a mode and use
the “+” and “-“
buttons to edit
the settings.
Unit is delivering
continuous training
stimulation
Red
N/A
Light is solid in
color for as long as
button is pressed
(up to 10 seconds)
N/A
N/A
N/A
Unit is delivering
momentary training
stimulation
Red
N/A
Light will quickly
flash once no
matter how long
button is pressed
N/A
N/A
N/A
