Sportable Scoreboards 2218LED, Руководство по установке

Страница: 9 / 13

9
3. Secure the junction box cover to the installed junction box.
At the scoreboard:
4. Remove the signal/power access door located on the back of panel A.
5. From the ground, run the control cable through a sealed, water-tight conduit then through a
water-tight conduit fitting into the left side of the signal cable/power access door and into the
scoreboard. A hole is provided for a conduit connector
6. Inside the scoreboard, connect the control cable leads to the appropriate terminals on the
terminal block, according to the label above the terminal block. The connections are as follows
connect the orange and bare wire of the cable to the terminal block opposite the black & gray
wire connection, connect the blue wire of the cable to the terminal block opposite the green
wire connection, connect the white with blue stripe of the cable to the terminal opposite the
white wire connection. Do not connect the white with the orange stripe of the cable UNLESS
YOU ARE USING A HAND HELD CONTROLLER THIS CONNECTION WILL HAVE TO BE
MADE AS FOLLOWS: Connect the white with orange stripe of the cable the terminal opposite
the red wire connection. MAKING THIS CONNECTION USING A LARGE CONTROLLER
WILL BURN THE CONTROLLER OUT. If you need assistance call 800-411-3136.