Operating/assembly instructions
Free-standing ballet barre
Prod. code: 122 4375
Page 1 of 3
02/2016
38367 Grasleben
/ Germany
Telephone: +49 (0)53 57/181 81
www.sport-thieme.com
Assembly instructions for the free-standing ballet barre
Thank you very much for choosing a
Sport-Thieme
product. We want to make sure
that you can enjoy this product, so here is some important advice for your safety as
well as for the use and maintenance of the equipment.
Please read these instructions fully before you assemble and use the equipment.
Included:
Illustration 1: Free-standing
ballet barre
Pos.
Description
1
4 x hex screw M10 x 35, with spring washer and cap nut
2
2 x base with rubber feet
3
2 x lower post
4
1 x cross strut with 4 x setscrew M8 x 16
5
2 x clamping lever
6
2 x upper post
7
1 x ballet barre, L = 2.00 m,
Ø
= 4.0 cm, with 4 wood screws 5 x 25
8
1 x hex key SW3 and SW4
1. General
The free-standing ballet barre's height can be freely adjusted between 85 and 110
cm. Using a clamping system, any height in-between can be set. Please ensure
that the barre is horizontal.
The free-standing ballet barre is only suitable
for its intended use
. Improper use
voids the warranty. Make sure you do not put too much weight on the barre and it
does not tip over.
This is a mobile piece of equipment that is not fixed to the floor!
