(
Note
) The SE Sport 400
TM
is not recommended for Volvos
with exhaust through the cavitation plate. The SE Sport 300
TM
is recommended.
Installation Adjustments:
Cavitation plates of 8“ width
require SE Sport 400
TM
modification for Drill-Free
TM
installation. Contact Sport Marine
Tech or www.sesport.com for written instructions and photos.
*The Mercury 40
HP
, 50
HP
, and 60
HP
FourStrokes
have a
6.5” plate width at the rear disk mount position. Pilot holes
are provided to guide drilling the Sport 400
TM
with a 1/4”
drill bit to fit these motors. Use the standard 6” hole position
for the forward Disk-GripTM mounts.
*The Honda 200
HP
and Yamaha 350
HP
have larger 7.25” wide plates. To mount
to these cavitation plates, you may need to slightly expand
the outside holdes outward with a small round rasp or 1/4”
drill.
*Various Evinrude 200
HP
- 300
HP
range models may
require drilling the 6.5” pilot hole, and expanding the forward
outside holes for the best fit. Measure for the closest hole
pattern before installation.
*Conventional Drill Assembly:
If you prefer to drill your
cavitation plate, set the Sport 400
TM
in the desired position
and mark the four inside holes with a center punch. Drill the
four inside hole placements using a 1/4” drill bit. Install using
the same hardware without the Disk-Grips
TM
and rubber
washers. (Or, optionally, choose to drill two holes and use
two Disk-Grips
TM
.)
© 2014 SPORT MARINE TECHNOLOGIES, INC.
SPORT MARINE TECHNOLOGIES
©
HIGH PERFORMANCE HYDROFOIL
4OO
TM
Video Online
TM
Video Installation also online at
sesport.com
Member
