MESH AND SOLID SAFETY COVER INSTALLATION GUIDE
Installing a Safety Cover
Pool
Edge
Cover
overlaps
pool edge
evenly
Center
Strap
Center
Strap
STEP 1
Remove the safety cover from the box and
carefully unfold.
Be sure cover is right side up, and protective strips
are on bottom.
Drape cover over the pool, it is easier to leave the
water at normal height, as cover will fl oat on water.
Stretch cover evenly over pool as tightly as pos-
sible. Water bags or 5 gallon buckets placed on
the straps can be used to temporarily secure cover
in place.
Adjust cover so that overlap is equal on all sides.
Attach the springs to the straps, leaving about 4”
of strap between the covers edge and the buckle,
and about 3” between the buckle and the spring.
This will allow for adjustment.
STEP 2
Find the center straps along the length and width.
Using a piece of chalk , mark a point 3” beyond the
uncompressed spring, or about 18” from covers
edge.
Using this mark as a guide, snap a chalk line along
the whole length of the pool. This will ensure that
the anchor’s will be parallel to pool.
Snapped
chalk line
Anchor
drill hole
location
Anchor
drill hole
location
3”
3”
3”
3”
15”
18”
Page
2
of 5
60 Campanelli Dr., Braintree, MA 02184 www.splashsupercenter.com
