5
e
Glide
Trainer
XG
200
1. The computer cable is pre-installed to the console mast and main frame so be careful not to pull too hard on
the console mast during assembly to avoid damaging them.
2. Connect cable (
100
) to (
101
).
3. Place the console mast onto the mating plate of the main frame; Be careful not to pinch the speed sensor wire
between the console mast and the main frame plates during assembly.
4. Secure the console mast in place with the four stainless steel bolts (
42
) and split washers (
50
). Make sure the
bolts are securely tightened using the 8mm Allen wrench (
108
).
5. Attach the hand brake lever (
90
) to the handlebars as follows:
HARDWARE
STEP 1:
Console Mast
#42.
M10 x 20mm
Stainless Steel Bolt
(4 pcs)
#50.
M10
Split Washer
(4 pcs)
Remove the screw that is threaded into the nut on the backside of the hand brake with the Phillips head
screw driver (
107
)
Place the hand brake bracket around the front of the right handlebar vertical tube, then insert the bolt
through the back of the bracket and thread back into the nut. Tighten with the Phillips head screw driver
(
107
)
Loosen the two cable retainer brackets on the back of the console mast with the Phillips head screw driver
(
107
) just enough to allow the cable to nest behind them. Retighten the screws after placing the cable
behind them.
Содержание Glide Trainer
Страница 2: ......
Страница 4: ...2 e Glide Trainer XG200...
