Spirit CR900, Руководство пользователя

Страница: 28 / 42

28
Dyaco Canada Inc. 2017 customerservice@dyaco.ca
GENERAL MAINTENANCE
1. Wipe down all areas in the sweat path with a damp cloth after each workout.
2. If a squeak, thump, clicking or rough feeling develops the main cause is most likely one of
two reasons:
1) The hardware was not sufficiently tightened during assembly. All bolts that were
installed during assembly need to be tightened as much as possible. It may be
necessary to use a larger wrench than the one provided if you cannot tighten the
bolts sufficiently. I cannot stress this point enough; 90% of calls to the service
department for noise issues can be traced to loose hardware.
2) The crank arm nut and/or the pedals need to be retightened.
3. If squeaks or other noises persist, check that the unit is properly leveled. There are 2
leveling pads on the bottom of the rear stabilizer, use a 14mm wrench (or adjustable
wrench) to adjust the levelers.
Cleaning
Almost all surfaces are washable. A damp cloth is sufficient to clean most surfaces of this unit.
Be careful not to drip water on the monitor. A mild liquid soap may be added if needed.
MAINTENANCE MODE MENU
The console has built-in maintenance/diagnostic software. The software will allow you to
change the console settings from English to Metric and turn off the beeping of the speaker
when a key is pressed for example. To enter the Maintenance Mode, pedal the bike and press
and hold down the Start, Stop and Enter keys. Keep holding the keys down for about 5
seconds and the Message Center will display Maintenance Mode. Press the Enter key to
access the menu below:
1. Key Test (Will allow you to test all the keys to make sure they are functioning)
2. Display Test (Tests all the display functions)
3. Sleep Mode (Turn on to have the console power down automatically after 20 minutes of
inactivity)
4. Odometer Reset (Resets the odometer)
5. Units (Sets the display to read out in English or Metric display measurements)
6. Speaker (Turns off the speaker so no beeping sound is heard)
7. Brake Test (Tests the brake resistance)
8. Sensor Test (Tests the speed sensor function)
9. Unit Type (Sets machine type; Bike or Elliptical)
10. Bootloader
11. CSafe test (tests the CSafe functions)
If an error occurs while running a test, please hold the Stop button for 3 seconds to clear the
error.