Customer Service 1-888-707-1880
Dyaco Canada Inc. 2021
Email: [email protected]
28
ENGINEERING
MODE
The console has built-in maintenance/diagnostic software. The software will allow you to change
the console settings from English to Metric and turn off the beeping of the speaker when a key is
pressed, for example. To enter the Maintenance Menu (may be called Engineering Mode,
depending on the version), press and hold down the
Start, Stop
and
Enter
keys; keep holding the
keys down for about 2 seconds, and the Message Window will display “Engineering Mode.” Press
the
Enter
button to access the menu below.
Press the
Up/Down
keys to navigate the menu, then press the
Enter
key to select functions (Key
Test, Display Test, Functions, Factory Set and Exit).
A.
Key Test
- Will allow you to test all the keys to make sure they are functioning
B.
Display Test
- Automatically tests all LCD’s
C.
Functions
- Press Enter to access settings, use
Up/Down
keys to scroll
i.
ODO Reset
- Resets the odometer
ii.
Units
- Sets the display to read out in Imperial (miles, pounds, feet, etc.) or Metric
(kilometres, kilograms, meters, etc.) display measurements
iii.
Sleep Mode
- Turn on to have the console power down automatically after 30 minutes
of inactivity
iv.
Motor Test
- Continually runs the tensioning gear motor
v.
Manual
- Allows stepping of the gear motor
vi.
Pause Mode
- Turn on to allow 5 minutes of pause, turn off to have console pause
indefinitely
vii.
Key Tone
- Turn on or off the beep sound when a key is pressed
D.
Factory
Set
E.
Exit-
Select to exit Maintenance Mode
