Customer service 1-888-707-1880
Dyaco Canada Inc 2013.
Email: [email protected]
11
STEP 4: CONSOLE, SEAT, COVERS, PEDALS
1. Install the front and rear stabilizer covers (32 & 37) and secure to the frame with four M5 x 12mm
screws (99).
2. Install the left and right cup holders (39 & 38) to the rear handlebars with four self tapping screws
(105).
3. Install the bottom seat cushion (61) to the seat carriage (4) with four M6 x 15mm screws (98).
4. Install the Pedals (116 L, 117 R) into the Crank arms (51L, 51R). Remember that the left pedal has
a reverse thread and will be screwed into the crank in the opposite rotation from normal threads.
There is an “L” stamped into the end of the threaded post of the left pedal and an “R” in the right.
Make sure to tighten the pedals as much as you possibly can. It may be necessary to re-tighten
the pedals if you feel a thumping during pedaling the bike. A clicking noise, or thumping, sound
during pedaling is usually caused by the pedals being too loose.
5. Connect the two wire harnesses (44 & 45) to the corresponding connectors on the back of the
console. Install the console onto the console mast and secure with four M5 x 12mm screws (99)
being careful to not pinch the wires.
