Spinning SPINPower Studio Crank, Руководство пользователя

Страница: 14 / 20

INSTALLING THE SPINPOWER
®
CRANK
(continued)
3. Once the crank has been tighened it is time to install the pedal.
Face the non-drive side of the bike and hand thread the first few
threads of the pedal onto the crank turning it counter clockwise.
Now use a 15mm pedal wrench on the flat section of the axle of the
pedal to completely tighten the pedal by turning the wrench over
the top towards the front of the bike (counter-clockwise). Note that
this is a special left-hand thread for this pedal and we tighten it by
turning the wrench counter-clockwise. Once installed, you are
now ready to calibrate the crank for complete accuracy.
CALIBRATING THE
SPINPOWER® CRANK
When installing this crank you must calibrate using the
SPINPower® Crank Connect App.. It is very important that you
calibrate the crank to ensure accurate power measurement.
You can also use tools in the app to name the crank and install
updated firmware.
CARE AND MAINTENANCE
Your SPINPower® crank is designed for accuracy and durability
in the home environment. If needed, the crank can be
cleaned with a soft cloth. Use a mild diluted solution of Simple
Green® or equivalent applied to the cloth. Do not spray any
cleaners directly on the crank (or the bike).
The battery (one CR2032) can be easily replaced when needed
and the instructions for replacement are at the beginning of
this manual. Always use high quality alkaline batteries such as
Duracel, Energizer or equivalent for optimal performance.
Periodically check the crank and pedal bolts as part of your
regular maintenence for your Spinner® bikes.
14