www.spinlock.co.uk
Handle Assembly Replacement
Handle Assembly Replacement
30
31
Handle Assembly Replacement XXC-HDLB
XXC0812
how to use
pages 14-15
installation
pages 20-21
spares
pages 36-37
1.
Remove the rope from the clutch.
2.
For Lock Open versions, ensure the lock open latch is in the down position.
3.
Lift handle and rotate fully open and then back to 90º vertical. Access to the M5 Allen screw
on the top surface that retains the rear moulding. Remove this screw.
4.
Hold rear cover at top, rotate and pull out from the top.
5.
Pull the complete rear moulding and jaw assembly free from the body
6.
Open handle fully to remove the M6 CSK screw on top of the product.
7.
Punch the 2 locating pins through the body (see diagram 1).
Note:
these have been locktite in
place. For the side mounted versions screw in a M4 fastener into the pin to lift and remove
(see diagram 2).
8.
Slide out the handle assembly through the rear of the body.
9.
Thoroughly clean with fresh water and inspect the following critical items:
Roller Cages (both are identical) -
unclip from jaw and look for signs of wear or flats on
the roller surfaces. If flats are found replace
XX-ROLL+
. Ensure rollers cages are re-attached in
correct orientation.
Jaw Bearing Surfaces -
ensure that both are clean and smooth.
Jaw Grip Surfaces -
clean off any rope debris. Check for excessive wear on the grip surface. If
the black anodised surface has aluminium showing through, replace with a new
XXC-JAW
Assembly.
Jaw Linkplates -
check these are attached to both sides of both jaws with pins and secured
by both pins. Ensure free movement of link plates/pins in jaws.
Release Pin -
located centrally in top jaw. Check for any signs of surface wear.
Clutch Body -
flush clean inside, paying particular attention to the upper and lower roller
surfaces, the two drainage runs in the base and their exits at the end mouldings.
Re-assembly
1.
Insert new handle, pins and M6 CSK screw.
2.
For Lock Open Versions ensure the lock open latch is in the down position.
3.
Lift handle and rotate fully open and then back to 90º vertical.
4.
Insert jaw assembly in body of XXC.
5.
Angle rear moulding backward, to locate lower fixing hooks in body.
6.
Rotate top of cover into place flush with XXC body.
7.
Insert M5 Allen screw on the top surface that retains the rear moulding. Hand tighten only.
8.
If Lock Open version, ensure latch is fully operational in both up and down positions as well as
opening and closing the handle fully.
9.
For standard versions, open and close the handle fully to ensure fully operational.
10.
Open handle fully and thread rope through XXC body. For lock open use latch to hold the
jaw open. See page 15 for rope insertion help.
1
2
Содержание XX0812/HP
Страница 46: ...www spinlock co uk ...
