32
2.3.6 - AIR REFRESHMENT
1 – With the air conditioner running on “AUTO mode”, the refreshment will work
according to the set-point temperature, searching for the comfort conditions
to the passengers.
This stands for both “cooling mode” as well as for “heating mode”.
a) The indicator (13) on informs when the air refreshment is
open.
b) The indicator (12) on informs when it is shut.
2 – During the cooling or heating, the air refreshment can be manually activated
pressing the key (RENOV). It will remain open for 10 seconds. After this period
it will close automatically, going back to the automatic cycle.
2.3.7 - INTERNAL AND EXTERNAL TEMPERATURE
The display will normally show the internal temperature of the vehicle.
1 – To verify the external temperature press key (TEMP).
2.3.5 - HEATING BY CONVEYORS
The “Heating Mode by Conveyors” is activated the same way as the “Roof
Heating” mode. (See item 2.4.4)
Note
: in case the air refreshment is open when the “cooling mode” starts to
work, it will be automatically shut.
*Conveyors – heating coils installed by the body manufacturer. They are normally located on the
lateral of the passenger’s aisle, below the seat
The display will show the external temperature for 5 seconds. While the external
temperature is shown on the display, the indicator (14) will be on.
After 5 seconds the display will return showing the internal temperature and
the indicator (14) will be off.
If the key (TEMP) is pressed before the pre-determined period of 5 seconds,
the display will show the internal temperature again.
2.3.8 - PROGRAMMING THE SET-POINT
1 – To adjust the set-point press on of the keys (INCREASE) or (DECREASE).
The set-point temperature will blink on the display.
2 – To program it simply press the key (INCREASE) to increase the
temperature or the key (DECREASE) to decrease the temperature, until the
desired temperature is found.
3 – After the desired temperature is selected, the display will keep blinking for
5 seconds. When it stops blinking, it will show the new internal temperature of
the vehicle and the set-point temperature will be reprogrammed.
Operation
