Operating Manual
9
1300-87075-1A
User Interface
Plug in the system to turn the power on. Once the system is turned
on, the Spex logo is displayed. The home screen appears as shown
to the left. If the system is in ECO mode, it will prompt you to wake it.
This screen will show upon power up. It will instruct you to close the
drawer to home the system and enable the unit to be ready to seal,
simply push the drawer in.
The screen will then show the sealing time, heater set temperature
and heater actual temperature along with the active status of the
heater block, cooling or heating depending on the temperature.
This is the main sealing screen. Here, you will see the main button to
press “seal” and begin the sealing process. Once you press this, you
will be prompted on how to complete the sealing procedure. Firstly,
place the correct plate adapter onto the shuttle, followed by the
plate and plate weight.
This screen will show once you press the seal button, it will prompt
you to ensure that the sealing plate is ready to be sealed, including
the correct plate support, the corresponding plate, the correct foil,
and finally the corresponding plate weight. Once all of these have
been checked, you can manually push the drawer in to begin the
sealing process. Once this is complete, the automated spring will
return the drawer back out.
Close drawer to
home system
Place plate foil
and foil weight
onto shuttle and
close drawer
