EN
14
Troubleshooting Guide
Problem
Possible Cause
Solution
Helicopter will
not bind to the
transmitter
(during bind-
ing)
Low flight battery or trans-
mitter battery voltage
Fully charge or replace the flight battery
and/or transmitter batteries
Transmitter is not in bind
mode
Power on the transmitter while hold-
ing the Trainer/Bind switch. Hold the
Trainer/Bind switch until binding is
complete
Transmitter too close
to the helicopter during
binding process
Power off the transmitter. Move the
transmitter further away from the
helicopter.
Disconnect and reconnect the flight bat-
tery to the helicopter and follow binding
instructions
Helicopter will
not link to the
transmitter
(after binding)
Helicopter is bound to a
different model memory
(ModelMatch
™
radios
only)
Disconnect the flight battery. Select the
correct model memory on the transmit-
ter. Reconnect the flight battery
Flight battery/Transmitter
battery charge is too low
Replace or recharge batteries
Flight control-
ler will not
initialize
Helicopter was moved
during initialization
If windy, lay helicopter on its side during
initialization
Transmitter is powered off Power on the transmitter
Controls are not centered Center elevator, aileron and rudder
controls. Make sure the throttle is at idle
Helicopter will
not respond to
the throttle but
responds to
other controls
Throttle not at idle and/or
throttle trim is too high
Lower the throttle stick and lower the
throttle trim
Transmitter is not in
normal mode or throttle
hold is on
Verify the transmitter is in normal mode
and throttle hold is off
Motor is not connected
to the ESC or the motor
wires are damaged
Connect the motor wires to the ESC and
check motor wires for damage
Flight battery charge is
too low
Replace or recharge flight battery
Throttle channel is re-
versed
Reverse the throttle channel on the
transmitter
