16
SPEKTRUM DX5 RUGGED • TRANSMITTER INSTRUCTION MANUAL
EN
MENU
CALIBRATE
Use this menu to calibrate controls. After making physical changes to the transmitter, such as changing the
wheel, calibrate the transmitter.
1.
Move the Steering Wheel, Throttle/Brake and the knob from stop to stop.
2.
Save when finished or cancel to go back.
TOUCH SETTINGS
5 different touch setting profiles are available to suit the driver.
•
Profile 1 has the slowest response (requires long touches or holds to navigate and make selections)
•
Touch response becomes more sensitive as the profile numbers increase
•
Profile 5 has the fastest response (requires short touches or holds to navigate and make selections)
SETTINGS (CONTINUED)
Press and hold the slide button while powering on the transmitter
to show the System Setup list. No radio transmission occurs when
a System Setup screen is displayed, preventing accidental dam-
age to linkages and servos during changes to programming.
UTILITIES
BA
CK
CLEAR
OK
MODEL SELECT
MODEL UTILITIES
Model Select enables you to access any of the 20 internal model memory locations in the Model Select list.
1.
Slide to the desired model memory in the Model Select list.
2.
When the desired model memory is highlighted, press OK to select the model. The transmitter returns to
the Main Screen.
3.
Add a new model by rolling to the bottom of the list. You will then be prompted with the Create New
Model screen.
CAUTION:
NEVER change the model in Model Select while operating a model. Changing the model
memory interrupts the transmitter signal to the receiver and may cause loss of vehicle control,
damage or personal injury.
In the Model Utilities function you can create a new model, delete a model, copy a model, reset a model to default
settings and sort the model list. If the DX5 Rugged is updated, use the Validate All selection to ensure model
settings are updated to be fully compatible with the new firmware. The Delete All selection will delete all model
settings.v
The System Setup menu can also be accessed from the Function list.
A CAUTION screen will appear that warns that RF will be disabled
(the transmitter will no longer transmit). Press
YES
to access the
System List. If no selection is made, the system will exit to the
main screen within approximately 10 seconds.
WARNING:
Do not press
YES
to enter the Utilities menu
unless the model is turned off and secured.
