0119327R1 Page 15 of 18
Warning!
Failure to comply with these instructions may result in accidents involving serious personal injury.
Failing to follow these instructions can result in the product being damaged or being destroyed.
Safety Information
General
Safe use of the system is possible only when the operating instructions are read
completely and the instructions contained are strictly observed. Failure to comply with
instructions marked with the ”NOTE” symbol may result in serious damage to the system
or one of its components.
• It is important for everyone who is to connect, install, or use the systems to have the
necessary information and access to the Owners Manual. Follow the instructions for
mounting – risk of injury if these instructions are not followed.
•
The appliance is not intended for use by young children or infi rm persons without supervision.
• If there is visible damage on the product it must not be installed.
•
Note that during construction of applications, in which the actuator is to be fi tted, there
must be no possibility of personal injury, for example the squeezing of fi ngers or arms.
Assure free space for movement of application in both directions
to avoid blockade.
Only for EU markets
• This appliance can be used by children aged from 8 years and above and persons
with reduced physical, sensory or mental capabilities or lack of experience and
knowledge if they have given supervision or instruction concerning use of the
appliance in a safe way and understand the hazards involved.
• Children shall not play with the appliance. Cleaning and user maintenance shall not
be made by children without supervision.
Only for Non-EU markets
• Persons who do not have the necessary experience or knowledge of the product/
products must not use the product/products. Besides, persons with reduced physical,
sensory or mental abilities must not use the product/products, unless they are under
surveillance or they have been thoroughly instructed in the use of the apparatus by a
person who is responsible for the safety of these persons.
• Moreover, children must be under surveillance to ensure that they do not play with
the product.
• It is the operator’s responsibility to ensure that there is free space for the application to
move without risk for the operator or bystanders before operating the application.
Misuse
• Do not overload the actuators – this can cause danger of personal injury and
damage to the system.
• Do not use the actuator system for lifting persons. Do not sit or stand on a table
while operating – risk of personal injury.
• Do not use the system in environments other than the intended indoor use.
Electric leg information
CBD4
DL6
Before installation, re-installation, or troubleshooting:
• Stop the DL5/DL6
• Pull out the mains plug.
• Relieve the DL5/DL6 of any loads, which may be released during the work.
Before start-up:
• Make sure that the system has been installed as instructed in this User Manual.
• Make sure that the voltage of the control box is correct before the system is connected
to the mains.
• System connection. The individual parts must be connected before the control box is
connected to the mains. See the User Manual for LINAK actuators, if necessary.
During operation
• If the control box makes unusual noise or smells, switch off the mains voltage immediately.
• Take care that the cables are not damaged.
• Unplug the mains cable on mobile equipment before it is moved.
• The products must only be used in an environment, that corresponds to their IP protection.
Misc.
The actuator system has a sound level below 55dB(A) in typical applications.
Updated manuals and declarations can always be found here:
www.linak.com/deskline
Repairs
In order to avoid the risk of malfunction, all DESKLINE® repairs must only be carried
out by authorised LINAK workshops or repairers, as special tools must be used and
special gaskets must be fi tted. Lifting units under warranty must also be returned to
authorised LINAK workshops.
Warning!
If any of the DESKLINE® products are opened, there will be a risk of
subsequent malfunction.
Warning!
The DESKLINE® systems do not withstand cutting oil.
