SpectraPure
®
SpectraPure
®
Inc.
480.894.5437 Call us toll-free 1.800.685.2783
2167 East Fifth St, Tempe, Arizona 85281
7
SETUP PROCEDURES
STEP 1: Unscrew the third position housing (MaxCap
®
DI) and the fourth position housing
(SilicaBuster DI) from the system and remove the DI Cartridges. Then, reinstall the empty
housings back onto the system.
STEP 2: Connect the 1/4" Black Line to the cold water line by using either the garden hose adapter,
which is provided with the system, or a Feed Water Adapter.
STEP 3: INSTALLATION USING THE HIGH & LOW FLOAT SWITCHES AND BULKHEAD FITTINGS:
A. Install both the High and Low Floats onto a open container, such as a RubberMaid
TM
trash can.
The floats can be mounted by drilling a 5/8" hole.
(The High Float shuts down the system, while the Low Float turns the system on).
B. Connect the floats to the “Y” adapter.
C. Attach the 3-pin connector on the float switches to the UHE CONTROL MODULE.
NOTE: Floats are to be mounted horizontal when dry and float up when wet. In most
instances we recommend locating the low float approx. halfway down your reservoir.
DO NOT OVERTIGHTEN when installing the floats.
NOTE: Floats must be installed in the FRESH WATER storage container.
This system MUST be connected to the floats to operate the Flush Cycle.
Failure to install the pure water flush connection for this unit will void any warranty.
(continued on next page)
Garden Hose
Adapter
Feed Water
Adapter
