46
Ventura MPC Storage Procedure
1. Turn the yellow service valve on the feed pump module to OFF (horizontal, see photo).
2. Push Auto Store to fresh water flush the system. Repeat, to flush the system twice.
3. Remove the cap on the service port on the feed pump module and install the inlet service
hose from the service kit. Remove the quick disconnect fitting from the brine discharge
outlet of the Clark Pump, and replace it with the quick disconnect brine discharge service
hose. Lead both hoses to a 5 gallon bucket.
4. Push the Auto Store button and run the feed pump until you have one gallon of fresh wa-
ter in the bucket from the brine discharge service hose. Stop the system.
5. Mix 1 container of SC-1 storage compound with the water in the bucket.
6. Make sure the pressure relief valve on the Clark Pump is OPEN (un-pressurized)
by turning 1/2 turn counterclockwise
7. Place the yellow service valve in the Service
position (pictured below).
8. Turn on the feed pump using the manual con-
trol switch on the MPC 5000 Control Box. The
solution will be drawn from the bucket with
the service hose, and returned to the bucket
from the brine discharge service hose. Circu-
late the storage chemical in the system for ap-
proximately 10 minutes. Turn off the feed
pump.
Clean Up
Remove the brine discharge service hose from the Clark Pump, and replace the brine dis-
charge hose that leads to the thru-hull. You may now pump the bucket dry by using the manu-
al control switch on the MPC Control Box.
Turn the service valve 180° back to the RUN position, and remove the inlet service hose. Close
the seacock, drain and clean the strainer and any filters in the system. Reassemble dry. Leave
the pressure relief valve open, since the next time you run the system you will need to purge
the storage chemicals with the system unpressurized.
Service valve OFF
Service hose connected and
service valve to SERVICE
Connecting brine dis-
charge service hose
Содержание Ventura 150T MPC
