1.
Nail Holes (3)
– allows you to hang the wall mount onto nails or screws.
2.
Locking Screws
– lock/unlock the wall mount at the wall molding or floor
track.
3.
Locking Knob - tightens/loosens the sliding bracket in place after it
has been positioned along the elevation scale.
4.
5/8“–11 Laser Mount – lets you connect the laser to the wall mount.
5.
Fine height adjustment screw - lets
you fine adjust the laser’s position
on the wall mount.
6.
Adjustment screw
– adjust the slider‘s movement tightness considering
the laser weigth.
7.
Elevation Scale
– provides graduated marks that indicate the position
of the laser relative to the wall molding height. The adjustment range
on the scale is from 3.1 cm (1 1/4 in.) above wall-molding height to
5 cm (2 in.) below it.
(The
“2“ position is aligned with the horizontal centerline at the
ceiling target.)
8.
Reading Edge
– allows you to adjust the laser position appropriate for
your application needs.
9.
Vertical-Alignment Notch
— shows the position of the laser beam when
the laser is set up in vertical mode and is moved up to the
top (3.1 cm [1 1/4 in.]) stop.
Note: The laser handle should be used as a safety hole - provide a
place to tie a safety wire when mounted to a wall.
1
2
3
4
6
5
2
7
8
9
Wall mount
