46
4.4.7 GPS
At the EVENT menu,
Move the cursor to the “GPS” using the
▲,▼
buttons.
Press the ENTER button when the cursor is on
the “GPS” and the following screen appears.
User can change the SHOCKSENSOR
“ON”,
“OFF” by pressing the
button.
NOTE:
It is possible to set the RELAY OUTPUT in the type of event, and it is possible to set the period of the
relay output from 1 to 30 seconds.
<RELAY SELECT>
There are POWER (N.C), USER, REC, NOT USED, ALARM, LOSS, MOTION and HDD ERROR,
you can select one type among the above 8 menu.
POWER:
The relay is working when power is off.
USER:
User can operate the relay output manually by pressing
the “FUNCTION” button
with (+) button
and
(-) button.
NC (Normal close)
→NO: press the (+) button with “FUNCTION” button.
NO (Normal open)
→NC: press the (-) button with “FUNCTION” button.
Press the “FUNCTION” button again if you want to exit this mode.
(You can also use this function through network viewer.)
REC:
The relay is working when start recording.
NOT USED:
If you want to not use this function, you can select
“NOT USED”
ALARM:
The relay is working when the alarm is ring.
LOSS:
The relay is working when the video loss is occurred.
MOTION:
The relay is working when the motion is occurred.
HDD ERROR:
The relay is working when the problems are occurred with HDD.
