5a. Removal of Liner
7
Fig. 6
B
ADU
S
TREAM
II
dimensional drawing
When replacing liner or removing liner for repairs;
remove 4 bolts (part #9/1) which hold square cover
(part #8) to jet housing. Remove all bolts (part #9/2 &
9/3) except top two, which hold the clamping ring
(part# 3 and gasket (part #12) to jet housing. Back
out the two remaining bolts approximately halfway
and check for any movement of jet housing from the
wall. (NOTE: If the two counter sunk bolts (part# 27)
which hold the jet housing to the wall were installed,
the jet housing should not move, and the two
remaining bolts can be removed.)
Remove one of the remaining two bolts and slide
clamping ring (part #3) to the side. Replace all the
bolts before removing the last bolt. Remove or
replace liner. Reverse process to install liner.
NOTE: When replacing clamping ring and bolts:
locate bolt heads under liner, make small cut on liner
at the bolt heads and push liner over bolt head.
.79"
5
.5
9
"
8
.2
7
"
6
.5
4
"
7
.3
2
"
4
.7
2
"
8.78 "
2.84"
4
.4
9
"
4
.9
2
"
1.97"
1.9
7"
4.
49
"
4.
92
"
®
