STARCUT
300
Skids
When operating on abrasive soils, particularly in stubbles and similar
conditions with thin ground cover, excessive skid wear may be expected. To
provide extra protection and to prolong life of the skids, special hard facing
rods are available.
If working in wet and muddy conditions, ensure that debris is not allowed to
build up on the deck.
Storage
Before storing away, thoroughly wash the machine removing all traces of
grass and dirt. Great care must be taken when washing with high-pressure
hoses, do not hold the water jet close to the paintwork. Use steam cleaners
with caution, be sure to remove all detergents to avoid any discolouring or
damage to paint.
Grease all grease points until fresh grease shows. Store PTO shaft in a dry
place.
After Storage
Check condition of the tyre (where applicable) and then follow the
maintenance procedure covered in the servicing part of this manual. Pay
particular attention to the condition of guards and blades.
Remember the Multicut/Starcut 300 is designed to withstand the most
rigorous conditions and, with a little care and attention, will give many years of
trouble free service.
So as not to invalidate the warranty and to avoid problems, use only genuine
parts and make sure the machine is not driven at a speed in excess of 1000
rpm on the PTO. As indicated on the speed sticker.
Blade Alignment:
Ensure the blade alignment is
maintained if the drive train is
dismantled, refit with the blade
carriers at 90 degrees from each
other to prevent blade collision.
16
