OTHER OPERATIONS
USER CODE
• The User Code needs to be set to avoid disturbance from remote controls when more than one smart toilets
are used in the house. Turn on the toilet for setting while turning off others. Press User Code combination
buttons (Press “STOP” button first and then press “REAR” button) to enter User Code Setting Mode, the
indicator lights will be on and keep flashing.
• (RF remote control) The Remote control will generate matching User Code automatically. Press User Code
combination buttons again to exit setting mode and setting is completed. The system will retain the User
Code even if there is loss of power to the unit or the remote control.
• (IR remote control) Press water volume “+”“-” buttons to select User Code. The indicator shows the
corresponding User Code. Press the User Code combination buttons again to save settings and exit. The
buzzer beeps and it’s set successfully. If there is a loss of power to either the unit or the remote control, the
User Code will be cleared and will need to be reset. After entering setting mode, if there’s no operation for
10s, the remote control will exit setting mode automatically and return to its previous state.
QUIET MODE
•”Quiet Mode” disables the audible “beep” when pressing activation buttons.
• Long press “SEAT TEMP” button to turn on/off quiet mode.
AUTO DEODORIZATION
• While holding down the "STOP" button, depress the "FRONT/MOVE" button to start or exit the Auto
Deodorizing function. When the Auto Deodorizing function is active, it will start deodorizing automatically
when it detects a user is seated for greater than 3 seconds. The Auto Deodorizing will turn off automatically
during the drying cycle. The Auto Deodorizing function is set to "ON" by default when the unit is equipped.
APP CODE MATCHING
• Press and hold “STOP” button and then press “ ” button to start APP code matching. (This button
combination only applies to product with APP.)
IMPORTANT SOUNDS
• The unit will audibly “BEEP” when the user presses one button which means the main unit receives the
signal and conduct the operation accordingly. If the system doesn't make a “BEEP”, it means the main unit
did not receive the signal. Please adjust the Remote Control direction and retry the button selection.
• If there is a loss of power during the spray operation, the wand will not retract into it's default position. If
possible, wait until power is restored, and allow the unit to reset to it's default position. Do not manually
press in the Spray Wand as you may cause damage.
• When a user is in the seated position on the Bidet, you will hear an audible "click". This means that the
functions of Front Cleaning, Rear Cleaning, and Drying are in operation. By default, the Spray Wand will
continue to spray for 1-2 seconds if a user stands during the cleaning process. Please press the "STOP"
button if you need to stand during the cleaning process.
