SpeakerCraft Vital 710, Руководство по установке, Страница: 30 / 36

30
Tape monitor (Audio Recording)
In Standby or with the Vital 710 power ON, press the
Tape-M button on the Vital 710 Remote to select the
Rear Panel Tape IN/OUT. With a three-head tape
deck or other device capable of outputting the
actual recorded signal, this selection allows listening
to the output of an audio recording device, while it
is recording, to confirm the quality of the recorded
signal.
1.
Select the Source to be recorded by pressing
that source button on the Vital 710 Front Panel or
Remote. The Source will be displayed in the Front
Panel Display as shown in Figure 33 .
2. Press the TAPE-M button on the Vital 710 Remote
to insert the Tape IN/OUT Loop. TAPE M will flash
slowly on the Front Panel Display to indicate Tape
Monitor is the signal being played at the speakers.
3.
With the source to be recorded playing, (Tuner
active, CD Play, etc) start the record process as
appropriate on the audio recorder connected to
the TAPE M Loop. A three-head recorder will out-
put the recorded signal for monitor. (A standard
two head recorder will typically pass the input
signal through to its output while recording.)
4.
To listen to the recorded content, after recording
is finished, play the recorded content from the
audio recorder via the TAPE M IN.
SP. A
MHz
PRESET CH.
TUNED STEREO TAPE M
Figure 33
Tape Monitor
Reset
In unusual circumstances, it may be necessary to reset the Vital 710 microprocessor. After a power outage or
surge, the Vital 710 may not fully restore to normal operation. It may also be used to reset the Vital 710 to fac-
tory defaults.
Note: Please remember Reset will clear all Tuner Preset programming.
1.
Turn the Main Power Switch on the Vital 710 Rear Panel OFF.
2.
Unplug the Power Cord for at least three minutes. Plug the Power Cord back in to the unswitched 110V AC
outlet. Turn the Main Power Switch back ON and try to operate the Vital 710. If it is still not operating prop-
erly, proceed with the following Reset Instructions .
3.
Set the Vital 710 to Standby. (ON/Standby button backlight red.)
4.
Press the Reset button on the Vital 710 Rear Panel. Try Vital 710 functions. If still not properly functional pro-
ceed to Step 5 .
5. With the Vital 710 in Standby, press and hold the Vital 710 Front Panel Preset Scan and Mute buttons until
the Firmware version appears on the Front Panel Display. Release the buttons. The display will flash a few
times and turn off. The Vital 710 will restore to Standby. If the Vital 710 still does not function properly, call
SpeakerCraft Technical Support at 1.877.888.9004.
OPERATING THE Vital 710
Vital 710 Remote