2.4. DELIVERY RANGE
The scope of delivery is presented in the handover report, which is attached to the table
documentation.
2.5. CONNECTIONS
The plasma burner for proper operation requires:
400V / 50Hz
Current protection:
B25 fuse
Compressed air supply:
8 bar pressure (flow depends on plasma source)
2.6. EQUIPMENT OPTIONS
1. CNC table with control
2. Plasma source Spartus CUT 65 CNC or Spartus CUT 105 CNC
3. Corel DRAW X5 graphics program
4. Section table
5. Water table
6. Voltage THC torch height regulator
Table equipment and option of additional equipment depend on individual orders placed by the
customer. The equipment options listed above are informative.
3.
BASIC SAFETY INSTRUCTIONS
3.1. INSTRUCTIONS
The basis of safe machine usage is knowledge of basic safety regulations and safety instructions. All
persons operating the machine are obliged to follow the instructions, and in particular, the safety
rules contained in this manual. In addition, the accident protection regulations apply at the place
where the machine is being used. The following information does not release the operator from the
obligation to comply with the occupational health and safety rules at work.
3.2. IMPORTANT SAFETY INDICATIONS
Safety indications are described in instructions which, if not followed, may endanger life or health.
These guidelines should be followed with extreme caution. These instructions should be given to all
machine operators.
3.3. GENERAL INFORMATION
In order to avoid possible accidents and to ensure trouble-free operation of the device, observe the
applicable health and safety regulations, fire regulations and the provisions of this manual.
The operating temperature in the room should be at least 5°C. A good visibility should be
guaranteed. The floor must be rough and even. Electrical and pneumatic supply lines must not be a
tripping hazard
Only trained (by the manufacturer) operators may be designated to operate the plasma burner
Any defects of the device should be reported immediately to those responsible for maintenance,
while the device should be absolutely shut down until the defect is repaired
Damaged or defective equipment must be repaired or taken out of service immediately
Any modifications or interventions in the construction of the machine will void the warranty
The use of non-genuine consumable parts may present a risk of electric shock or explosion, and
may also damage machine parts
The use of non-genuine consumable parts is prohibited and will void the warranty
