Spartus 101X, Руководство пользователя

Страница: 13 / 20

USER’S MANUAL
EN
11
5.2.5 Adjusting the distance between face and helmet
If the distance between the welder’s face and the helmet body is too small, change the distance
settings. Headgear has 3 levels of distance regulation. To set right distance from the face use
the mechanizm
20 .
Release pin and set the right distance level. Remember that it has to be
simetrical regulated on both sides of headgear.
5.2.6 Incline angle adjustment
An inappropriate angle of inclination may cause discomfort during operation or cause the visor
to move over the head of the operator when tilting the head.
Incline angle adjustment can be made by using angle adjusting shim
17
in to both sides.
5.2.7 Turning on the grind mode
SPARTUS ® helmets have a grinding function. To enable the grinding function, set the switch
1
into GRIND position. The degree of protection for the grinding function is DIN 4.
6. MAINTENANCE
Maintenance and repair work may be performed only by qualified personnel with the appropriate
permissions. Regular maintenance provides adequate service life and trouble-free operation of the
welding helmet.
Daily: (before use/installation):
• Perform visual inspection of the helmet, knobs, welding filter.
• Check for proper operation of welding filter using TEST button
5
.
• Visually inspect the technical condition of the outer guard and the inner guard. Worn or
damaged covers should be replaced by a new one.
• Visually inspect the technical condition of the optical sensors.
At least once a month:
• Visually inspect the sweatband. When worn replace by a new one.
Once a year:
• You should send welding helmet to an authorized service center for an interim review.
• Replace the battery that powers the welding filter.