Spartherm S-Vent 100, Инструкция по установке и эксплуатации

Страница: 9 / 16

GB
GB
9
Press the  button to cycle through the blower speeds.
Button  Audible Signal Blower
first press one short Stage 1
second press two short Stage 2
third press three short Stage 3
fourth press two short Stage 2
fifth press one short Stage 1
sixth press one long off
The next time the  button is pressed, the blower will start up again on
Stage 1.
Note:
Even in manual mode, the blower will switch on automatically when
the sensor temperature reaches approx. 105°C (switch-off temperature
approx. 100°C). This function cannot be disabled. Its purpose is to prevent
overheating of the convection air housing.
5.2.2. AUTOMATIC MODE
Description: In this mode, when the switch-on temperature is reached the
blower runs automatically at the preset speed. The speed can be adjusted
via the
 button (as in Manual mode). The blower switches off again
when the temperature falls below the switch-on temperature.
Pressing the
AUT (orange)
button on the remote control enables Automatic
mode. This is acknowledged by the control unit with a ‘long audible signal’.
The switch-on temperature is factory-set to approx. 45°C. See Section „6.2.
Setting the Switch-on Temperature“.
5.2.1. MANUAL MODE
Description: In this mode the operator selects the blower speed via the
remote control. The integral temperature sensor is not active. The desired
blower speed can be selected via the
 button.
Pressing the MAN (blue) button on the remote control enables Manual mode.
This is acknowledged by the control unit with a ‘long audible signal’.
LED
Automatic
mode
Manual
mode
Speed selector
switch
Proportional mode