Spartherm S-Vent 100, Инструкция по установке и эксплуатации

Страница: 4 / 16

GB
4
1. SCOPE OF SUPPLY
The S-Vent 100 modular forced convection system is supplied in a folding
box containing:
• Blower unit with air distributor
• Control unit with remote control
• Temperature sensor with approx. 2 metres connecting lead
• 4 pipe connections with 2 cover plates
• Flexible aluminium connecting tube (1m length)
• Connecting lead with mains plug 230 V
• Control unit - blower unit connecting lead
• Hardware (clamps and screws)
• Installation and operating manual
Weight approx. 10 kg including shipping packaging.
2. GENERAL INFORMATION
Before your fireplace is assembled and installed you should meet with the
master chimney sweep responsible for such matters in your area. He will
advise you on the building regulations and suitability of your chimney and
will carry out the acceptance test on your fireplace insert.
The fireplace insert must be installed, connected to the chimney and oper-
ated in compliance with national and European standards, the relevant
national and local guidelines and regulations and, in particular, the relevant
Heating Regulation (FeuVO) of the Federal state (Germany) and the Technical
Rules of the Stove and Hot Air Heating System Trade (TROL).
2.1. TECHNICAL DATA
Control unit:
Model: FC715 TiEmme
Supply voltage: 230V AC, 50Hz
Permissible connected load (blower): max. 80 W
Switching stages: I - III
Power consumption on standby: approx. 1W
Protection class I: Earthed conductor (PE)
Type of protection: IP50
Fuse line side: Fine-wire fuse F 2A / 250V
Blower:
Model: DAE133D ebmpabst
Rated voltage: 230 V, 50 Hz
Max. power consumption: 73W
Nominal flow stage III: 320 m
3
/h (without resistance)
Installation
example
Varia 1Vh
Blower unit
Control unit
Temperature sensor
Flexible aluminium
Pipe connection