4.
Utility
– This command contains various tools such as Pre-Scan, the checking of the drive and controller
information, firmware revisions, etc. Please refer to the “Utility” section of this manual for details.
5.
Setup
– This command contains options to configure the duplicator system. The Setup menu is truncated
when the DiscLock feature is enabled. The three functions available under the DiscLock Setup menu are
as followed:
1.
Auto Start Time:
Set the amount of time before the duplicator will automatically start.
Note: When the DiscLock feature is enabled, the master disc plus at least one blank disc
must be placed in the duplicator accordingly before the duplicator can perform Auto Start.
Î
Press ENT
Î
Î
i
or
j
to set
seconds and press
ENT to confirm
2.
Button Beep:
Turns the audio signal (a beeping sound) ON or OFF for pressing of the
buttons.
Î
Press ENT
Î
Î
i
or
j
to select
mode and press ENT
to confirm
3.
Language:
Sets the language selection of the display. Available languages are: English
(default), Spanish, Portuguese, and Japanese.
Î
Press ENT
Î
Î
Press
i
,
j
to
select language
6.
Image Manager (HDD required)
–This command is for the management of the hard disk drive (HDD)
installed in the duplicator, such as information and image(s) stored on the HDD. Please refer to the
“Image Manager” section of this manual for details.
Note:
This feature is only available on duplicators with a HDD
installed. If there is no HDD present in the duplicator, this feature will NOT show in the menu of commands.
7.
Disable DiscLock
–
Disables the DiscLock feature so the copies will remain in their original state. No
protection will be implemented on the copies discs. The menu will go back to its original list of commends
and setting.
Note: if there is no HDD present, this feature will be #6 instead of #7.
Î
Press ENT to disable DiscLock
and return to the normal menu
Î
19