The lightstrip will change from one color to another over time, then back to
the first.
•
“While channel number __ is active”
- The fade effect persists only
while the channel is active, so a continuous input signal is needed.
•
“fade lightstrip number __ back and forth”
- Select which lightstrip
you wish the fade effect to operate on. To have the same effect on
multiple lightstrips, you must create multiple actions.
•
“from color” color picker
- This is the initial color that the lightstrip
will power up with.
•
“to color” color picker
- The other color, which the strip fades to
and from periodically.
•
“fade speed” slider
- Controls how fast the fading action occurs.
Fill
Fills some number of lights on the light strip with a single color. Blanks the
other lights to off.
•
“listen to channel number __”
- A momentary signal on this
channel is all that is needed to trigger a fill operation, and the fill will
persist until another effect starts.
•
“wait for __ seconds”
- This delay allows for sequencing effects.
Most often you’ll probably set it to 0.
•
“clear lightstrip number __”
- Select the lightstrip to operate upon.
•
“and fill __ pixels”
- The number of pixels, from closest to the Light
board out, to turn on.
Light pixel
Page 14 of 33
7
