Caution!
The location of the
monitor may not impair the
visibility of the driver! Further, do
not impair the functionality and operation
of equipment, control units and systems
inside the vehicle. Follow applicable laws
and safety regulations for vehicles!
Image 12
Monitor locking
lever
Monitor
swivels
Locking screw
Locking
lever
▪
Insert the square monitor socket on the
monitor arm into the designated notch
at the back of the monitor. Now slide the
monitor bracket upward until it catches
(see image 12).
▪
Open the locknut and adjust the monitor
to the desired viewing angle. Now
tighten the locknut to secure the monitor.
▪
Clean the area of the windshield where
you would like to attach the suction cup
base. Now press the suction cup base
onto the windshield and move the
locking lever toward the suction cup
base.
▪
Now plug the monitor cable into
the vehicle's outlet (12 V). Place the
monitor cable so as not to impact or
jeopardize the safety of the vehicle and
its passengers.
4.2 Installing the monitor
Step 8: Installing the transmitter
Remove the protective film from the
adhesive strip at the top of the transmitter
and affix in a protected location behind the
trunk trim. Also secure the transmitter with
two cable ties . Be sure there are no
electrical loads in the direct vicinity of the
transmitter to avoid impairing the
transmission. Now secure the camera and
transmitter cables run in the void of the
trunk with cable ties . The cables run
may not interfere with the vehicle‘s
functionality!
Step 9: Check the transmitter power
supply cable
First engage the hand brake and be sure
the vehicle is not shifted into gear.
Vehicles with automatic transmission must
be in
”P“
for parking lock. Turn the
ignition to II but do not start the engine!
Push the button ( ) to power on the
monitor. If the transmitter is correctly
connected, a signal will now be trans-
mitted to the monitor when putting the car
into reverse and the monitor displays the
camera‘s viewing range.
If no image is displayed on the monitor
you may further check the camera power
supply with the hand brake engaged (or
vehicle in
”P“
for parking lock on vehicles
with automatic transmission), ignition
turned (II) and the vehicle in reverse with
a simple test. Do not start the engine!
Completely cover the camera with both
palms cupped to darken the camera
surroundings and activate the night vision
sensor. Leave a slight opening between
your thumbs and look into your palms. If
the camera is active, all 7 LEDs around
the camera will light up red. If the LEDs do
not light up check the camera‘s cable and
terminal connections. Also see item 4.7 on
page 25.
4
4
12
10
2
GB
23
98106_Rueckfahrkamera_Manual _27_03_12_print
Dienstag, 27. M
rz 2012 14:09:16
