Images and actual product may vary
slightly. Subject to change for the purpose
of technical advances. Accessories not
included.
Immediately after unpacking check all
parts for damage and verify all parts are
present!
Do not use the backup camera system if
damaged, incorrect on-screen display or if
the instructions for use are missing!
1 LCD - Monitor 2,7 " (6,8 cm)
1 Monitor arm with suction cup base
1 Monitor cable with 12 V plug
1 Camera with connector cable
2 Camera mounting brackets
1 Radio transmitter
1 Connector cable for transmitter
4 Cable ties
2 Clamped cable connections
2 Thread screws
2 Locking nuts
1 Plastic ring
1 Instructions for use
3.1 Contents
3.0 PRODUCT DESCRIPTION
2.2.17 Run the cables so as not to cause
tripping hazards and the cables cannot be
damaged by e.g. objects with sharp
edges! Do not run cables across hot
surfaces!
2.2.16 Do not wear metal body jewelry
when installing the backup camera
system. Doing so could result in a short
circuit and burns!
2.2.15 When removing dirt or ice and
snow from the camera lens be extremely
careful so as not to scratch it.
2.2.14 If you are unsure how to install the
backup camera system consult a qualified
specialist or have the system installed by
a qualified specialist.
2.2.13 Even if the fuse inside the 12 V
plug is tripped, backup camera system‘s
camera and wireless transmitter will
remain ready for use.
2.2.12 Improper installation of the backup
camera system may damage the vehicle‘s
electrical equipment. This could result in
an accident or fire.
Caution! Risk of property damage and
personal injury!
2.2.11 Be sure the ignition and all vehicle
loads are powered off before starting with
installation of the backup camera system!
2.2.10 If operation system malfunctions
and damage to the backup camera
system occurs during operation,
immediately disconnect the equipment
from the 12 V vehicle power supply!
2.2.9 When installing the backup camera
system always be sure the safety and
functionality of other systems and
equipment in the vehicle is not impaired!
Please follow the instructions of the
automaker‘s manual.
2.2.8
Risk of short circuits!
Verify the
correct polarity when connecting the
camera cable to the vehicle power. Refer
to the manual for notices and the
automaker‘s wiring diagram.
2.2.7 During installation be sure cables
are securely and tightly mounted. Do not
mount these to conductive materials. If
cables are run through walls with sharp
edges (metal sheets, etc.) use ductwork
or conduit to prevent cable damage.
Protect cables from damage, do not bend.
Immediately replace damaged cables!
GB
19
98106_Rueckfahrkamera_Manual _27_03_12_print
Dienstag, 27. M
rz 2012 14:09:15
