Page 9
SP-SW5100-VUHD Users Guide
Basic Operation
Selecting a New Source Device to Display
Selecting a New Source Device to Display
To display a new source, press the Source Selector button on the Front of the SP-SW5100-VUHD
repeatedly until the LED on the Active Source Indicator corresponds to the desired Source Port
Selection. That image should now be visible on the Display Output and can be heard on the
Stereo Audio Output connectors.
Note: Selecting an input for a source that is not physcially connected will cause the output
display to indicate that the signal has been lost or disconnected.
Selecting a New Source Device to Display
Selecting a New Source Device to Display
(Using IR Remote)
(Using IR Remote)
From the IR Remote controller, shown below, select the Right or Left buttons until the desired
Source is selected. If the front panel is viewable, you will see the Active Source Indicator change
when each button is pressed.
Connected Source Indicator
