18
19
4. If the battery pack does not charge properly:
(1) Check the main socket by plugging in a lamp or other
appliance.
(2) Move the charger and battery pack to a location where the
surrounding air temperature is approximately 18-24
o
C.
(3) If charging problems persist, take or send the tool, battery
pack and charger to your local service centre.
5. The battery pack should be recharged when it fails to
produce sufficient power on jobs which were easily
done previously. DO NOT CONTINUE to use under these
conditions. Follow the charging procedure. You may also
charge a partially used pack whenever you desire with no
adverse effect on the battery pack.
6. Under certain conditions, with the charger plugged in to
the power supply, the exposed charging contacts inside the
charger can be shorted by foreign material. Foreign materials
of a conductive nature, such as, but not limited to, steel wool,
aluminium foil, or any buildup of metallic particles, should be
kept away from charger cavities. Always unplug the charger
from the power supply when there is no battery pack in the
cavity. Unplug the charger before attempting to clean it.
7.
Do not immerse the charger in water or any other liquid.
WARNING!
Don’t allow any liquid to get inside the charger; electric
shocks may result. To facilitate the cooling of the battery
pack after use, avoid placing the charger or battery pack
in a warm environment, such as in a metal shed, or an
un-insulated trailer.
WARNING!
Never attempt to open the battery pack for any reason. If
the plastic housing of the battery pack breaks or cracks,
return to a service centre for recycling; do not put it into
further use.
INSTALL THE GUARD
1. Remove one screw from the motor housing.
2. Slide the guard over the motor housing.
3. Re-insert the screw into the guard and tighten.
CONNECT THE UPPER HANDLE AND LOWER
SHAFT
1. Plug the upper handle into the lower shaft.
2. Tighten the knob (C) to make sure it is tight.
REMOVE OR INSTALL THE BATTERY PACK
WARNING!
Always release the on/off trigger before insertion or
removal of the battery pack.
Remove the battery pack. Depress the button (D) on the two
sides of the battery pack, and then remove the pack (E) from the
tool.
Install the battery pack. Align the ribs on both sides of the
B
C
