O
PERATION
I
NFRARED
C
HEESE
M
ELTER
P
AGE
8
OF
28
I
NSTALLATION AND
O
PERATION
M
ANUAL
1186531 R
EV
0 (12/05)
O
PERATION
DANGER
EXPLOSION HAZARD
In the event a gas odor is detected, shut down equipment at the main shutoff valve. Immediately call the
emergency phone number of your gas supplier.
CAUTION
If the Cheese Melter pilots should go out the flow of gas to the Cheese Melter burners is NOT interrupted.
Consequently, it is the responsibility of the operator to check the ignition of the burners immediately EVERY TIME
the Cheese Melter is turned on. Should ignition fail after 10 seconds, turn off burners, wait 5 minutes, and then try
again.
NOTICE
Southbend infrared Cheese Melters cook food in about half the time of conventional Cheese Melters, so adjust
cooking times.
Southbend infrared Cheese Melters are unique in design. They incorporate our exclusive ceramic tile burners, which
generate infrared rays that provide better quality products in about one-half the usual broiling time, and with less gas
input than ordinary Cheese Melters. Very little energy is wasted in heating secondary surfaces, which is necessary for
conventional-type Cheese Melters.
Since the surface of the ceramic tiles becomes red hot in less than one-half minute, the Cheese Melter is ready to
start broiling with a very short preheat time, thereby saving time, labor and energy. These glowing surfaces emit
intense infrared rays, which are transmitted directly onto the product, thereby yielding better tasting broiled food in
less time.
The Cheese Melter design supplies 100% clean primary air to the burners, ensuring efficient combustion and
maintaining full production capacity and maximum recovery, even in the most severe conditions of grease vapors and
smoke atmospheres, which are created during any broiling process.
Southbend infrared Cheese Melters provide such rapid speed and recovery that broiling techniques may
require some modification in order to take full advantage of their productive capabilities.
The location of the
Cheese Melter
controls and other components are shown in Figure 3 below.
Figure 3
Cheese Melter Operation
Chrome Rack
Removable
Grease
Drawer
Variable Adjust HI-OFF
Independent Temperature
Control Knobs
Optional 4” Legs
Pilot Locations
Rear Gas Supply
(3/8” NPT Male)
Flue Vent
