H
EAVY
D
UTY
C
OUTERLINE
OPERATOR’S MANUAL 1195059 REV 4 (10/15)
PAGE
14
OF
28
OPERATION OF MANUAL GRIDDLE MODELS
Each 12”-wide and 18” wide model only griddle section has a knob on the front panel that directly controls the flow of gas,
and so the heat. Turn the knob clockwise to increase the heat; turn it counterclockwise to reduce the heat.
After each period of use, allow the griddle surface to cool normally. At the end of each day’s use, turn all control knobs
to the “OFF” position. After the griddle has cooled, coat the griddle surface with a light film of cooking oil to protect the
surface from moisture.
To shut down the appliance for an extended period (or before disconnecting the gas supply), turn all the burner control
gas knobs “OFF,” then turn the main gas supply valve(s) to “OFF.”
To light the pilots of a manual griddle section, do the following:
1. Turn all griddle controls to the “OFF” position.
2. Light the pilot tube located next to each burner. The pilot flame can be adjusted by turning the screw on the end of
the pilot fitting.
3. Turn burner knobs to “HI” position. The burners should have a 1/2” to 5/8” steady blue flame. Adjust if necessary.
4. To turn burners off, turn knob to “OFF” position.
O
PERATION
Figure 6
Left Pilot
Right Pilot
(36" & 48" Models)
The drawing below shows a Model HDG-36-M with the front panels removed to show the interior parts.
Note: 24" models have one pilot, 36" and 48" models have two pilots, 60" models have three pilots, and 72" models have four pilots.
The pilots can be viewed and lit through openings on the
front panel (Model HDG-36-M shown).
Note:
18” and 24” models have one pilot, 36” and 48” models have two pilots, 60” models have three pilots, and 72”
models have four pilots
Total Restaurant Supply - https://totalsupply1.com - Toll Free 1-800-944-9304 - Local 507-288-9454
2940 Hwy 14 W, Rochester, MN 55901
