South bend SB1118, Руководство пользователя

Страница: 52 / 84

-50-
For Machines Mfd. Since 10/21
South Bend Tools
Model SB1118
S E R V I C E
Calibrating Table
Height Indicator
The indicator on the depth scale should match
the value shown in the bottom window of the
digital readout.
To calibrate table height scale:
1. Raise table all the way up.
2. Loosen (2) cap screws shown in Figure 65.
3. Adjust scale pointer to
1
⁄
4
" mark on scale,
then tighten cap screws (see Figure 65).
Items Needed Qty
Hex Wrench 4mm .................................................1
Items Needed Qty
Hex Wrench 4mm .................................................1
Flat Head Screwdriver ..........................................1
Motor Brushes (SB1118380-3) ...................... 1 Set
To replace feed motor brushes:
1. DISCONNECT MACHINE FROM POWER!
2. Remove rear access panel.
3. Remove brush caps and worn brushes, (see
Figure 66).
4. Replace both motor brushes, then install
brush caps.
5.
Install rear access panel.
Replacing Feed Motor
Brushes
This planer is equipped with a universal motor
that uses two carbon brushes to transmit
electrical current inside the motor. These
brushes are considered to be regular "wear
items" or "consumables" that will need to be
replaced during the life of the motor. The
frequency of required replacement is often
related to how much the motor is used and how
hard it is pushed.
Replace the carbon brushes at the same time
when the motor no longer reaches full power,
or when the brushes measure less than
1
⁄
4
" long
(new brushes are
5
⁄
8
" long).
Figure 65. Location of adjustment screws for table
height scale.
Cap Screws Cap Screws
Scale Pointer Scale Pointer
Figure 66. Feed motor brush location. Figure 66. Feed motor brush location.
!
Feed Motor Feed Motor
Brush Cover Brush Cover
(1 of 2) (1 of 2)
!