South bend SB1091, Руководство пользователя

Страница: 40 / 60

Straightedge
Outfeed Table Infeed Table
Figure 42. Infeed and outfeed tables set evenly.
Figure 39. Screw cover and set screw location.
Screw Cover
Set Screw
(Out of View)
Figure 40. Front eccentric bushings.
Figure 41. Rear eccentric bushings.
-38-
For Machines Mfd. Since 10/20
South Bend Tools
Model SB1091
S E R V I C E
IMPORTANT: The steps below are intended to be
performed in succession with the steps involved
in checking the outfeed table. DO NOT proceed
until those steps are followed.
To adjust table parallelism:
1. Place straightedge on outfeed table so it
hangs over cutterhead, then lower outfeed
table until straightedge just touches
cutterhead body, as shown in Figure 34
(rotate cutterhead if necessary).
2. Remove screw cover (see Figure 39)
covering each set screw on outfeed table.
Note: It may help to clean screw covers with
electrical parts cleaner. Push duct tape firmly
against cover, then pull straight up.
3. Loosen each set screw (see Figure 39) two
turns.
4. Place straightedge in one of the positions
shown in Figure 38, and adjust table by
turning eccentric bushings (Figures 40–41)
as needed with an adjustable wrench so that
straightedge touches cutterhead while lying
flat across outfeed table. Repeat this step
with each remaining straightedge positions
as many times as necessary until outfeed
table is parallel with cutterhead to within
0.010"-0.012".
Note: Setting the outfeed table parallel to the
cutterhead within 0.010"-0.012" will produce
high quality results. Going lower than this
number will produce minimal gain.
5. Tighten set screws and re-install screw
covers on outfeed table.
6. Remove (4) screw covers on infeed table, and
loosen set screws underneath two turns.
7. Place straightedge halfway across infeed
table and halfway over outfeed table, then
adjust infeed table even with outfeed table,
as shown in Figure 42.