For Machines Mfg. Since 3/11
16-Speed Gearhead Lathe
-39-
O P E R A T I O N
To mount a non-concentric workpiece to the
faceplate:
1.
DISCONNECT LATHE FROM POWER!
2.
Protect the bedway with a piece of plywood.
3.
With the help from another person or a
holding device to support the workpiece,
position it onto the faceplate and clamp it in
place with a minimum of three independent
clamping devices (see
Figure 45
for an
example).
Be sure to take into account the rotational
and cutting forces that will be applied to the
workpiece when clamping it to the faceplate.
If necessary, use counter-weights to balance
the assembly.
Tailstock
Graduated Dial
Increments .....................................................0.001"
One Full Revolution ......................................0.100"
Increments on Quill
Inch .................................... 0"-6" in
1
⁄
8
" Increments
Metric ..................... 0–160mm in 1mm Increments
Positioning Tailstock
1.
Pull the tailstock lock lever backward (away
from the spindle) to unlock the tailstock from
the bedway.
2.
Slide the tailstock to the desired position.
3.
Push the tailstock lock lever forward (toward
the spindle) to lock the tailstock against the
bedway.
Using Quill
1.
Release the quill lock lever.
2.
Turn the tailstock handwheel clockwise
to move the quill toward the spindle or
counterclockwise to move it away from it.
3.
Push the quill lock forward to lock the quill
in place.
Figure 46. Tailstock and quill lock levers in locked
position.
Quill Lock
Lever
Tailstock
Handwheel
Tailstock Lock Lever
The tailstock (see
Figure 46
) is typically used
to support long workpieces by means of a live or
dead center (refer to
Centers
on
Page 43
). It
can also be used to hold a drill or chuck to bore
holes in the center of a part. Custom arbors and
tapers can also be cut on your lathe by using the
offset tailstock adjustment.
Figure 45. Example photo of workpiece clamped in a
faceplate.
Clamp
Faceplate
Non-Cylindrical
Workpiece
Downloaded from
www.Manualslib.com
manuals search engine
