TRANSMITTER PROGRAMMING
ENTERING REMOTE PROGRAM MODE
The system can lean up to 3 different transmitter codes. Each remote to be used MUST be
programmed together during the same sequence. For security, when a new remote is
programmed all previous remote’s are deleted. Please see remote operation chart for
information on using Second Car / Pad Lock Operations
.
Press and HOLD the valet switch, siren will chirp ONCE
(If siren does not chirp repeat step 1)
CONTINUE TO HOLD until siren chirps 5 times
Press & Release LOCK button on 1st Remote to be
Programmed for Normal Operation
If remote(s) are to be
programmed for "PADLOCK" skip and goto step 6
Press & Release the Trunk Button on Remote to be
Programmed for 2ND CAR OR PADLOCK operation.
Siren will Chirp 1 time to confirm remote has been programmed
(If siren does not chirp press button again)
Siren will Chirp 1 time to confirm remote has been programmed
(If siren does not chirp press button again)
PROGRAMMING REMOTE’S
Cycle the Ignition Key - ON/OFF ON/OFF ON
(Leaving the key ON)
Turn ignition key OFF to exit remote program mode when all
required remote’s have been programmed.
1 chirp confirms program mode entered followed by
5 chirps confirming transmitter program mode
1 -
2 -
3 -
4 -
6 -
5 -
7 -
8 -
REPEAT STEP 4 IF A SECOND REMOTE IS TO BE PROGRAMMED FOR NORMAL OPERATION
REPEAT STEP 6 IF A SECOND REMOTE IS TO BE PROGRAMMED FOR 2ND CAR / PADLOCK OPERATION
NOTE: ALL REMOTE’S TO BE USED MUST BE PROGRAMMED IN SEQUENCE
WHILE IN REMOTE PROGRAM MODE, RE-ENTERING REMOTE PROGRAM MODE
WILL ERASE ALL PREVIOUS REMOTE’S
SYSTEM PROGRAMMING -
Menu 1
INSTALL MANUAL
TRANSMITTER PROGRAMMING
AL.1
